Description
Trenton #2 Wax-Tape provides long-lasting corrosion protection for above-ground metal surfaces, pipes or fittings to prevent corrosion. It is recommended when abrasive blasting or painting are impractical. It resists weathering and UV without the need for an additional outer coat or outer wrap. It is a non-woven, non-stitch bonded synthetic fabric, saturated with a blend of microcrystalline wax, solvents and corrosion inhibitors (no clay fillers), forming a tape wrapper that firms up and is suitable for painting.
Advantages
Minimal surface preparation
Readily conforms to irregular shapes
Non-toxic, non-carcinogenic, low VOCs
Resists corrosive industrial atmospheres
Can be applied over wet surfaces
Compatible with other coatings
Tape firms up and does not require additional outer coat or outer wrap
Excellent resistance to weathering and UV
Can be painted after firming up
Application Procedure
Wire brush and scrape the surface clean of loose mill scale, rust, paint and other foreign matter. Apply a thin film of Wax-Tape Primer. If the surface is wet, cold or rusty, then rub and press on primer firmly to displace the moisture and ensure adhesion. Then wrap #2 Wax-Tape using a 1” overlap. While wrapping, press and mold the tape into conformity, ensuring that there are no air pockets or voids, so that the tape is in intimate contact with the surface. Also, press and smooth out lap seams to ensure that they are sealed. If the tape is going to be painted, allow a few days for it to firm up.
Packaging
4" x 9 rolls (24 rolls/case), 35 lbs/case
6" x 9 rolls (16 rolls/case), 35 lbs/case
Special widths and lengths available
Specifications
|
Color, #2 Wax-Tape |
Brown |
|
Color, #2A Wax-Tape |
Aluminum. Also available in white, yellow, red, blue, green |
|
Thickness |
70-90 mils |
|
Weight |
4 lbs/sq yd |
|
Dielectric strength |
100 volts/mil |
|
Operating temperature |
-50°F to 120°F |
|
Saturant pour point |
115°F to 125°F |
本月特價
分享儀器
.jpg)
則表面密封膠.jpg)
.jpg)
隱藏對比框